16v Mini Club Forums  

Go Back   16v Mini Club Forums > General Public Area > Other Hybrid Chat

Thread Tools Display Modes
Old 19-06-2019, 01:01 PM   #1
Junior Member
Join Date: Jun 2010
Posts: 18
Default IACV - MG Rover 5 wire valve in MM housing?

First post for a while on here I think so hello!

I am trying to run a mini MPi IACV in a magnetti marreli housing as shown below because I already have the plenum designed and built to suit the MM IACV. However the Emerald K3 ECU I am running can not operate the four wire MM valve.

Mini Mpi IACV part number is MDQ100040 and is confirmed OK with the Emerald K3

I think the tip geometry is similar enough between the two that it will seal in the housing but have very little knowledge of how the valve finds the end stop position.

Can anyone provide any insight?

adcyork is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 07:42 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.