16v Mini Club Forums  

Go Back   16v Mini Club Forums > General Public Area > Rover Chat

Reply
 
Thread Tools Display Modes
Old 09-03-2019, 07:48 PM   #1
twincamtone
Member
 
twincamtone's Avatar
 
Join Date: Feb 2017
Location: Cornwall
Posts: 89
Subframe: Home Made
CC: 1796
Make: Rover
ECU: Standard MEMS3
Default Driveshaft Endfloat

Hey guys, I'm at the point of measuring up to cut the driveshafts to have them sleeved. What endfloat do you guys have when the driveshafts are horizontal?
twincamtone is offline   Reply With Quote
Old 11-03-2019, 09:54 AM   #2
gazwad
Senior Member
 
gazwad's Avatar
 
Join Date: Sep 2006
Location: northampton
Posts: 2,030
Subframe: Home Made
CC: 1796
Make: Rover
ECU: standard
Default

10-20mm from fully in the inner joint should be fine. make sure your camber etc it roughly correct as this will effect it.
gazwad is offline   Reply With Quote
Old 11-03-2019, 05:33 PM   #3
twincamtone
Member
 
twincamtone's Avatar
 
Join Date: Feb 2017
Location: Cornwall
Posts: 89
Subframe: Home Made
CC: 1796
Make: Rover
ECU: Standard MEMS3
Default

Cheers Gaz, much appreciated
twincamtone is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 04:13 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.