Special tools - Page 2

AGoaty · 18-10-2018, 06:02 AM

Quote:

Originally Posted by Yellow

Ad says 1.4 only. I guess it must for the 1.8 VVC pulleys too? Only asking as as I need to get one (or do people use 2 so you can lock both ends?)

Sent from my iPhone using Tapatalk

I cannot understand why it says 1.4 only. The 1.4, 1.6 and 1.8 heads are identical. The VVC is obviously different but the front of the engine timing setup are the same as a non VVC???

InstantCustard · 18-10-2018, 07:36 AM

All the timing tools are the same.

Sent from my iPhone using Tapatalk

Yellow · 18-10-2018, 08:34 AM

Andrew when I started my project the belt was 2 years done and you told me it would be due again before I hit the road. I thought you were being rather pessimistic. I'm just glad I didn't do it then or I'd be considering a second replacement

Sent from my iPhone using Tapatalk

AGoaty · 18-10-2018, 07:04 PM

Quote:

Originally Posted by Yellow

Andrew when I started my project the belt was 2 years done and you told me it would be due again before I hit the road. I thought you were being rather pessimistic. I'm just glad I didn't do it then or I'd be considering a second replacement

Sent from my iPhone using Tapatalk

James, only one comment. "Pull your finger out!".

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

18-10-2018, 08:34 AM	#18
Yellow Senior Member Join Date: May 2009 Location: Aylesbury, Bucks Posts: 524 Subframe: Home Made CC: 1.8VVC Make: Rover ECU: Rover MEMS3 with Kmaps upgrade	Andrew when I started my project the belt was 2 years done and you told me it would be due again before I hit the road. I thought you were being rather pessimistic. I'm just glad I didn't do it then or I'd be considering a second replacement Sent from my iPhone using Tapatalk