16v Mini Club Forums  

Go Back   16v Mini Club Forums > General Public Area > General 16v Mini Chat

Thread Tools Display Modes
Old 08-07-2018, 12:18 PM   #1
mm man
Senior Member
Join Date: Dec 2009
Posts: 220
Default Rear hub nut torque setting for Mark D set up

I have a set of Mark D spacers fitted and intend fitting Suzuki rear hubs inc Suzuki bearings my question is what torque setting to use so I donít put excessive strain on the nut and shaft pin .
Suzuki is 150-200 nm and a mini is 81 nm does anyone know what his pins with standard mini castle nuts are rated at .

I tried to message Mark directly but his folder is full so canít receive messages.
mm man is offline   Reply With Quote
Old 08-07-2018, 02:29 PM   #2
Senior Member
ardonfast's Avatar
Join Date: Oct 2011
Location: dunkeswell airfeald devon
Posts: 7,879
Subframe: AMT
CC: 2000
Make: Vauxhall
ECU: dizzy/webers

I allways found this a can of worms, in general I do them up
To what I think is Sencible and feel the way it turns,
The thing is this! If you box them up at a torque and the castle holes don't meet the safety pin hole,
Shims?? I have even used half the pin if it's close,
Play it by ear as it's safe and can't go very far,
Soz about wonky discription by t don't know how to say it,
"yuck ,more like a 3 r2"
ardonfast is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 06:53 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.