View Single Post
Old 11-06-2007, 04:22 PM   #26
Senior Member
Pete_H's Avatar
Join Date: Mar 2007
Location: Worcester
Posts: 698
Subframe: Home Made
CC: 1333
Make: Suzuki
ECU: megasquirt
Send a message via MSN to Pete_H

A few pics...not for 56k (if any1 uses it anymore)

Engine sitting in cut frame...

Rear of frame cut out for clearance

Pulley clearance may be an issue...engine not all the way back yet.

Back of jig...bit of triangulation to stop subframe twisting.

sumpguard...Will try and combine with subframe for extra strength

Tilt of engine...may be adjusted but will help with clearance on bulkhead a bit

front section of jig can be unbolted and slide right out so subframe can be removed

Pete_H is offline   Reply With Quote